Saving Simulation Structure

[Snook]

Hi All,

I recently tried to setup a simulation, but keep getting an Abort message pop up as soon as a try to run it (right after MARK creates a .DBF file). Is there anyway to access the simulation structure from the .DBF file, so I can try to run the Sim again? If not, is there any way to save the simulation structure before I run the simulation, so I can more effectively troubleshoot?

[claudiapenaloza]

Snook,

If MARK has already created a .DBF for your simulation, you should be able to access whatever models you'd specified by opening a new MARK session, going to "File/Simulations/Modify Simulation File" and browsing for the simulation .DBF you want.
but... are you sure MARK has created a .DBF before a full iteration of you simulation ran? If so, you should be ok and the above process should work.

fingers crossed,
cp